The multiplex network door ECU receives signals from the half latch switch, initial switch, pawl switch and back door courtesy switch, which are built into the back door lock assembly. Based on these switch signals, the latch position of the back door lock assembly is determined.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2251 | Back Door Closer Switch Malfunction | While the back door closer is operating, a malfunction is detected in position information from the back door courtesy switch within a specified amount of time. | ·
Back door lock assembly ·
Harness or connector ·
Multiplex network door ECU |
If the replacement, removal and installation of the multiplex network door ECU or disconnection of the connectors of the multiplex network door ECU has been performed, initialize the power back door system*.
Click hereVehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>INITIALIZATION
The back door closer system uses the meter / gauge system function. First, confirm that there is no malfunction in the meter / gauge system. Refer to the How to Proceed with Troubleshooting procedure.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
*: w/ Power Back Door System
Read the Data List according to the display on the GTS.
Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR CLOSER SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Courtesy SW | Back door courtesy switch signal | ON or OFF | ON: Back door open
OFF: Back door closed |
*: Refer to "CONSTRUCTION AND OPERATION" |
*: Refer to "CONSTRUCTION AND OPERATION"
Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR CLOSER SYSTEM>SYSTEM DESCRIPTION
| Tester Display |
|---|
| Courtesy SW |
The display is as specified in the normal condition column.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the back door lock assembly.
Inspect the back door lock assembly.
Click hereVehicle Interior>DOOR LOCK>REAR DOOR LOCK>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
w/ Power Back Door System:
Disconnect the V23 back door lock assembly connector.
Disconnect the V12 multiplex network door ECU connector.
Disconnect the G9 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V23-4 (CTY) - V12-20 (FUL) | Always | Below 1 Ω |
| V23-1 (E) - Body ground | Always | Below 1 Ω |
| V23-4 (CTY) or V12-20 (FUL) - Body ground | Always | 10 kΩ or higher |
w/o Power Back Door System:
Disconnect the V23 back door lock assembly connector.
Disconnect the V25 multiplex network door ECU connector.
Disconnect the G9 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V23-4 (CTY) - V25-20 (FUL) | Always | Below 1 Ω |
| V23-1 (E) - Body ground | Always | Below 1 Ω |
| V23-4 (CTY) or V25-20 (FUL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG