Home › Vehicle Exterior › DOOR / HATCH › REAR DOOR › from 2016.01
RM3270E _59 Vehicle Exterior _041717 DOOR / HATCH _0205103 REAR DOOR A

DOOR / HATCH  REAR DOOR  DISASSEMBLY  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door disassembly/reassembly are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal
w/ Power Back Door System:

Reset back door close position


Power back door system (Click here)

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.

·

Fully open the rear door glass sub-assembly RH before proceeding with work.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67673A 3.REMOVE REAR DOOR FRAME GARNISH RH

a.
B408724

Detach the clip and claw and remove the rear door frame garnish RH.


Hide 74250 4.REMOVE REAR ARMREST ASSEMBLY RH

a.
B408725C01
0,0 0,0 false
V100135

Order of Removal
V113147

Remove in this Direction


Detach the clip and claw and remove the rear armrest assembly RH.


Hide 5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

a.
B408727C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the clip and claw.


b.

Disconnect the connector and remove the rear power window regulator switch assembly with rear door armrest base panel.


Hide 84810D 6.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

Hide 81230 7.REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 67665D 8.REMOVE REAR DOOR TRIM REFLECTOR RH (w/ Reflex Reflector Assembly)

a.
B405481C01
0.094,0.115 0.406,0.313 0.313,0.198 10 true *A 0.094,2.313 0.406,2.51 0.313,0.198 10 true *B
*A for RH side
*B for LH side
V100155

Protective Tape
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Put protective tape around the reflex reflector.


b.

Using a thin-bladed screwdriver, detach the claw and guide.

HINT:

Tape the thin-bladed screwdriver tip before use.



c.

Remove the rear door trim reflector RH.


Hide 69283A 9.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG RH

a.
B408729

Using moulding remover A, detach the claw and remove the rear door inside handle bezel plug RH as shown in the illustration.


Hide 67603 10.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY RH

a.
B408731

Remove the 3 screws.


b.
B408732C01
0,0 0,0 false
V113146

Place Hands Here
V100135

Order of Removal (1)
V100136

Order of Removal (2)
V113147

Remove in this Direction


Detach the clip as shown in the illustration.


c.
B408734C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the guide and remove the rear door trim board sub-assembly RH as shown in the illustration.


d.
B409014C02
0.792,0.979 0.792,0.469 0.792,0.469 1.094,0.469 true 0.792,1.292 0.792,1.75 0.792,1.75 1.135,1.75 true 1.094,0.375 1.344,0.573 0.25,0.198 10 true *1 1.125,1.656 1.375,1.854 0.25,0.198 10 true *2
*1 Rear Door Inside Looking Cable Assembly RH
*2 Rear Door Lock Remote Control Cable Assembly RH
V113147

Remove in this Direction


Detach the clamp and disconnect the rear door lock remote control cable assembly RH and rear door inside looking cable assembly RH as shown in the illustration.


Hide 69205A 11.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY RH

a.
B408736C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw and guide and remove the rear door inside handle sub-assembly RH.


Hide 68173B 12.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP RH

a.
B408738C01
0,0 0,0 false
V113147

Remove in this Direction


Raise the claw of the rear door inner glass weatherstrip RH as shown in the illustration, and then remove the rear door inner glass weatherstrip RH from the rear door trim board sub-assembly RH.


Hide 86160B 13.REMOVE REAR SPEAKER ASSEMBLY

Hide 67841E 14.REMOVE REAR DOOR SERVICE HOLE COVER RH

a.
B408740C01
0,0 0,0 false
V100143

Butyl Tape


Pull out the rear door lock remote control cable assembly RH, rear door inside locking cable assembly RH and wire harness from the rear door service hole cover RH, and then remove the rear door service hole cover RH.

NOTICE:

Remove any remaining butyl tape from the rear door panel.



Hide 15.REMOVE SCREW GROMMET

a.
B408742

Using a clip remover, detach the claw and remove the 2 screw grommets.


Hide 68142C 16.REMOVE REAR DOOR GLASS RUN RH

a.
B408743

Detach the guide and remove the rear door glass run RH.


Hide 67407E 17.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY RH

a.
B408744C01
0,0 0,0 false
V100135

Bolt
V100136

Screw


Lift up the rear door weatherstrip RH and remove the screw.


b.

Remove the 2 bolts and rear door window division bar sub-assembly RH.


Hide 68103 18.REMOVE REAR DOOR GLASS SUB-ASSEMBLY RH

a.
B408745

Remove the rear door glass sub-assembly RH from the rear door window regulator sub-assembly RH as shown in the illustration.


b.
B408746C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Remove the rear door glass sub-assembly RH as indicated by the arrows in the order shown in the illustration.

NOTICE:

Be careful not to damage the rear door glass sub-assembly RH.



Hide 68123B 19.REMOVE REAR DOOR QUARTER WINDOW GLASS RH

a.
B408749C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the rear door quarter window glass RH together with the rear door quarter window weatherstrip RH.


Hide 68188 20.REMOVE REAR DOOR QUARTER WINDOW WEATHERSTRIP RH

a.
B408751

Remove the rear door quarter window weatherstrip RH from the rear door quarter window glass RH.


Hide 75723 21.REMOVE REAR DOOR REAR BELT MOULDING RH

HINT:

The procedure described below is for the LH side.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR DOOR BELT MOULDING>REMOVAL


Hide 75730 22.REMOVE REAR DOOR BELT MOULDING ASSEMBLY RH

HINT:

The procedure described below is for the LH side.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR DOOR BELT MOULDING>REMOVAL


Hide 69803 23.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY RH

a.
B408752C01
0,0 0,0 false
V100135

Bolt
V100136

Connector
V100137

Temporarily Bolt


Disconnect the connector.


b.

Loosen the temporarily bolt.

NOTICE:

Do not remove the temporarily bolt. If the temporarily bolt is removed, the rear door window regulator sub-assembly RH may fall and become damaged.



c.

Remove the 4 bolts and rear door window regulator sub-assembly RH.


Hide 85710F 24.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

Hide 67836 25.REMOVE REAR DOOR LOCK CHILD PROTECTION COVER RH

a.
B408753

Remove the rear door lock child protection cover RH.


Hide 69330 26.REMOVE REAR DOOR LOCK ASSEMBLY RH

Hide 69037 27.REMOVE REAR DOOR LOCK COVER SUB-ASSEMBLY RH (w/o Double Locking System)

Hide 69730D 28.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY RH

Hide 69770B 29.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY RH

Hide 69318D 30.REMOVE DOOR LOCK WIRING HARNESS SEAL

Hide 69227M 31.REMOVE REAR DOOR OUTSIDE HANDLE COVER

a.
B408762C01
0,0 0,0 false
V113147

Remove in this Direction


Using a T30 "TORX" socket wrench, loosen the screw.


b.

Detach the claw and remove the rear door outside handle cover as shown in the illustration.


Hide 69230 32.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY RH

a.
B408764C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the rear door outside handle assembly RH as shown in the illustration.


Hide 69241G 33.REMOVE REAR DOOR FRONT OUTSIDE HANDLE PAD

a.
B408766C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw and remove the rear door front outside handle pad.


Hide 69242G 34.REMOVE REAR DOOR REAR OUTSIDE HANDLE PAD

a.
B408768C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw and remove the rear door rear outside handle pad.


Hide 69203A 35.REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY RH

a.
B408771C01
2.188,0.594 2.188,0.281 2.188,0.281 2.531,0.281 true 1.052,0.521 1.052,0.208 1.052,0.208 0.865,0.208 true 0.844,1.156 1.063,1.156 1.063,1.156 1.063,0.854 true 2.427,0.198 2.656,0.438 0.229,0.24 10 true *a 0.708,0.115 0.938,0.323 0.229,0.208 10 true *b 0.708,1.031 0.938,1.24 0.229,0.208 10 true *b
*a Grommet
*b Guide
V113147

Remove in this Direction


Using a T30 "TORX" socket wrench, loosen the screw.


b.

Detach the grommet and guide and remove the rear door outside handle frame sub-assembly RH.


Hide 67003C 36.REMOVE REAR DOOR PANEL CUSHION

a.
B408772

Detach the claw and remove the 2 rear door panel cushions.


Hide 68630D 37.REMOVE REAR DOOR CHECK ASSEMBLY RH

a.
B408773C01
0,0 0,0 false
V100135

Bolt (A)
V100136

Bolt (B)


Remove the 2 bolts (A), bolt (B) and rear door check assembly RH.


Hide 67871 38.REMOVE REAR DOOR WEATHERSTRIP RH

a.
B409005C01
0,0 0,0 false
V100155

Double-sided Tape


Using a clip remover, detach the clip and remove the rear door weatherstrip RH.

NOTICE:

Remove any remaining double-sided tape from the rear door panel RH.



Hide 67837C 39.REMOVE REAR DOOR DUST PROOF SEAL

a.
B409006

Detach the claw and remove the 3 rear door dust proof seals.


Hide 75923C 40.REMOVE NO. 2 BLACK OUT TAPE RH

HINT:

The procedure described below is for the LH side.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Rear Door)>REMOVAL


Hide 75925C 41.REMOVE NO. 3 BLACK OUT TAPE RH

HINT:

The procedure described below is for the LH side.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Rear Door)>REMOVAL