Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING ECU › from 2016.01
RM3270E _59 Vehicle Exterior _041720 LIGHTING (EXT) _0199686 HEADLIGHT LEVELING ECU A

LIGHTING (EXT)  HEADLIGHT LEVELING ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the headlight leveling ECU assembly installation/removal are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Disconnect cable from negative battery terminal w/ Power Back Door System:
Reset back door close position
Power back door system (Click here)
The headlight leveling ECU assembly is replaced with a new one Headlight leveling ECU assembly vehicle information registration Automatic headlight beam level control system (Click here)
Headlight leveling ECU assembly initialization

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for RHD vehicles.



PROCEDURE

Hide 45287 1.REMOVE LOWER STEERING COLUMN COVER

Hide 2. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

for Type A:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION

for Type B:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55667 4.REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH

Hide 55011A 5.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55606 6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 73900 7.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 89960 8.REMOVE HEADLIGHT LEVELING ECU ASSEMBLY

a.
E319917

Disconnect the connector.


b.
E319918

Remove the nut and headlight leveling ECU assembly.