Home › Engine / Hybrid System › 1KD-FTV COOLING › WATER PUMP(When Using the Variable Pin Wrench) › from 2016.01
RM3270E _51 Engine / Hybrid System _048919 1KD-FTV COOLING _0307750 WATER PUMP(When Using the Variable Pin Wrench) A

1KD-FTV COOLING  WATER PUMP(When Using the Variable Pin Wrench)  INSTALLATION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 16100 1.INSTALL ENGINE WATER PUMP ASSEMBLY

a.

Install a new gasket and the engine water pump assembly with the 5 bolts and 2 nuts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 13523 3.INSTALL CAMSHAFT TIMING PULLEY

a.

Install SST (pin 7.5) to SST (variable pin wrench arm assembly).

SST
09960-10010  (09962-01000)
09963-00750  


b.
A380869N02
0.833,1.844 0.979,1.844 0.979,1.844 1.073,1.313 true 2.813,1.427 2.656,1.427 2.656,1.427 2.375,0.927 true 0.531,1.75 0.854,1.958 0.323,0.208 10 false SST 2.854,1.323 3.177,1.531 0.323,0.208 10 false SST

Set SST to the holes of the camshaft timing pulley.

HINT:

Securely insert SST into the holes of the camshaft timing pulley so that SST is aligned with the center of the camshaft timing pulley set bolt.



c.
A380572C02
2.052,0.781 2.625,0.51 2.625,0.51 2.854,0.51 true 2.885,0.344 3.344,0.542 0.458,0.198 10 true SST
V100135

Turn


While holding SST, tighten the camshaft timing pulley.

Torque:
98 N*m (999 kgf*cm, 72 ft.*lbf)


Hide 13505 4.INSTALL NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

Hide 11322A 6.INSTALL NO. 1 TIMING BELT COVER

Hide 16620 7.INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

Hide 10.INSTALL NO. 2 IDLE PULLEY ASSEMBLY

Hide 88320 11.CONNECT COOLER COMPRESSOR ASSEMBLY

Hide 16711 12.INSTALL FAN SHROUD

Hide 16470 13.INSTALL RADIATOR RESERVOIR

Hide 44369A 14.INSTALL OIL RESERVOIR BRACKET

Hide 44360 15.CONNECT VANE PUMP OIL RESERVOIR ASSEMBLY

Hide 16571C 16.INSTALL NO. 1 RADIATOR HOSE

Hide 17.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 19.INSPECT FOR COOLANT LEAK

Hide 51410 20.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY