1.TIGHTEN BOLTS AND NUTS
Tighten the bolts and nuts on the chassis parts listed below, if necessary.
Front axle and suspension
Drivetrain
Rear axle and suspension
Brake system
Engine mounting
Other chassis parts
Tighten the bolts and nuts on the body parts listed below, if necessary.
Seat belt system
Seats
Doors and hood
Body mountings
Fuel tank
Exhaust pipe system
Other body parts
2.INSPECT TIRE AND INFLATION PRESSURE
Check the tires for wear and proper inflation pressure (See page Suspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION).
3.INSPECT LIGHTS, HORN, WIPERS AND WASHERS
4.CLEAN OR REPLACE AIR CONDITIONING FILTER
Remove the air conditioning filter (See page Vehicle Interior>HEATING / AIR CONDITIONING>BLOWER UNIT>DISASSEMBLY).
Visually inspect the surface of the air conditioning filter.
If the air conditioning filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.
Some filters are not able to be cleaned.
5.INSPECT REFRIGERANT AMOUNT FOR AIR CONDITIONER
Check the refrigerant pressure (See page Vehicle Interior>HEATING / AIR CONDITIONING>REFRIGERANT>ON-VEHICLE INSPECTION).
6.CORROSION INSPECTION
7.ROAD TEST
Check the engine and chassis for abnormal noises.
Check that the brakes work properly and do not drag.
Check that the parking brake operates properly.
8. FINAL INSPECTION
Check the operation of the body parts.
Hood
Auxiliary catch operates properly.
Hood locks securely when closed.
Front doors
Door locks operate properly.
Doors close properly.
Rear doors
Door locks operate properly.
Doors close properly.
Back door
Door lock operates properly.
Door closes properly.
Seats
Seat adjusts easily and lock securely in any position.
Seatbacks locks securely in any position.
Fold-down seatbacks lock securely.
Be sure to deliver a clean car. Make sure to check the following:
Steering wheel
Shift lever knob
All switches and knobs
Door handles
Seats