Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM
RM1880E _53 Suspension _013225 TIRE / WHEEL _0068557 TIRE AND WHEEL SYSTEM G

TIRE / WHEEL  TIRE AND WHEEL SYSTEM  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIRES

a.

Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:
Tire Size Front
kPa (kgf/cm2, psi)
Rear
kPa (kgf/cm2, psi)
205/65R15 94S 230 (2.3, 33) 230 (2.3, 33)



b.
C137874

Using a dial indicator, check the runout of the tires.

Maximum tire runout:

3.0 mm (0.118 in.)



Hide 2.ROTATE TIRES

a.
C237752
0.521,0.448 0.906,0.75 0.385,0.302 10 false *a 0.521,2.167 1.146,2.531 0.625,0.365 10 false *a 1.813,1.927 2.469,2.292 0.656,0.365 10 false *c 1.802,0.188 2.063,0.396 0.26,0.208 10 false *b
*a Front of the Vehicle
*b Vehicle Wheels and Spare Tire Wheel are Same Type
*c Vehicle Wheels are Aluminum but Spare Tire Wheel is Steel


Rotate the tires as shown in the illustration.


Hide 3.INSPECT WHEEL BALANCE

a.
C144019

Check and adjust the off-the-car balance.

Standard Imbalance after Adjustment:

14 g (0.030 lb) or less


HINT:
·

The inner side balance weight should be installed by clipping it to the rim.

·

If necessary, check and adjust the on-the-car balance.