1.INSTALL NO. 2 ECM BRACKET
Install the No. 2 ECM bracket with the 2 screws.
2.INSTALL NO. 1 ECM BRACKET
Install the No. 1 ECM bracket with the 2 screws.
3.INSTALL ECM
Install the ECM with the bolt and 2 nuts.
Connect the 4 connectors.
4.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
6.PERFORM INITIALIZATION