Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068455 CRANKSHAFT POSITION SENSOR A

2TR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL CRANKSHAFT POSITION SENSOR

a.
A301635C03
1.49,1.365 1.417,1.677 1.417,1.677 1.208,1.677 false 1.01,1.573 1.323,1.729 0.313,0.156 10 false *1
*1 O-Ring


Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.

Install the crankshaft position sensor with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing the sensor.



c.

Connect the crankshaft position sensor connector to the connector bracket.


d.

Attach the harness clamp.


e.

Connect the crankshaft position sensor connector.


Hide 2.INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET

Hide 3.INSTALL COOLER COMPRESSOR ASSEMBLY

A301364N02
2.458,1.042 3.156,1.042 true 2.74,1.167 2.896,1.365 0.156,0.198 10 false 1 2.677,1.615 2.885,1.844 0.208,0.229 10 false 3 1.438,0.781 1.594,0.979 0.156,0.198 10 false 4 1.656,0 1.854,0.198 0.198,0.198 10 false 2 3.208,0.969 3.365,1.167 0.156,0.198 10 false A

a.

Temporarily install the compressor with the bolt labeled A.


b.

Install the remaining 3 bolts, and then tighten the 4 bolts in the order shown in the illustration.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

NOTICE:

In order to prevent misalignment, which causes belt rattle, tightening of the bolts must be performed in the order shown.



c.

Connect the cooler compressor connector.


d.

Connect the suction hose sub-assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)