Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › SFI SYSTEM
RM1880E _51 Engine / Hybrid System _013209 2TR-FE ENGINE CONTROL _0068463 SFI SYSTEM C

2TR-FE ENGINE CONTROL  SFI SYSTEM  P0606  ECM / PCM Processor  


DESCRIPTION

·

The ECM monitors the input signals of the accelerator pedal position sensor No. 1. When the input signals and control signals deviate, a DTC is stored.

·

The ECM monitors the input signals of the throttle position sensor No. 1 and stop light switch. If the input signals and control signals deviate, a DTC is stored.

·

The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store a DTC immediately.


DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0606 ECM / PCM Processor Either condition is met (1 trip detection logic):
·

There is an ECM main CPU error.

·

There is an ECM sub CPU error.


ECM Comes on DTC stored

MONITOR STRATEGY

Required sensors/Components ECM
Frequency of Operation Continuous: ECM / PCM processor
Once per driving cycle: Internal control module accelerator pedal position performance, Internal control module throttle position performance

TYPICAL MALFUNCTION THRESHOLDS

When one of following conditions is met: Condition 1, 2 or 3
1. Difference of main accelerator pedal position and sub accelerator pedal position 0.3 V or more
2. Difference of main throttle position and sub throttle position 0.3 V or more
3. Stop light switch signal (CPU) and stop light switch signal (Monitor IC) Different

CONFIRMATION DRIVING PATTERN

1.

Turn the ignition switch off.

2.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

3.

Connect the cable to the negative (-) battery terminal.

4.

Turn the ignition switch to ON and wait for 16 seconds or more.


PROCEDURE

1.CHECK FOR DTC
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Clear the DTCs.

Click hereEngine / Hybrid System>2TR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR

Powertrain > Engine > Clear DTCs
50002 61

e.

Turn the intelligent tester off.


f.

Turn the ignition switch off.


g.

Disconnect the intelligent tester.


h.

Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.


i.

Connect the cable to the negative (-) battery terminal.


j.

Connect the intelligent tester to the DLC3.


k.

Turn the ignition switch to ON and turn the intelligent tester on.


l.

Wait 16 second or more.


m.

Enter the following menus: Powertrain / Engine and ECT / DTC.

Powertrain > Engine > Trouble Codes
50001 61

n.

Check for DTCs.

OK:

P0606 is not output.



Result:
Proceed to
OK
NG



OK

NG