1.INSTALL FRONT CRANKSHAFT OIL SEAL
Apply MP grease to the lip of a new oil seal.
Do not allow foreign matter to contact the lip of the oil seal.
Do not allow MP grease to contact the dust seal.
Temporarily install the oil seal to the timing chain cover.
Using SST and a hammer, tap in the oil seal until its surface is flush with the chain cover edge.
Keep the lip free from foreign matter.
Do not tap the oil seal at an angle.
2.INSTALL CRANKSHAFT PULLEY
3.INSTALL FAN SHROUD
4.CONNECT RADIATOR HOSE INLET
5.ADD ENGINE COOLANT
6.INSPECT FOR COOLANT LEAK
7.INSPECT FOR OIL LEAK
8.INSPECT ENGINE OIL LEVEL