Home › Engine / Hybrid System › 2TR-FE FUEL › FUEL FILTER
RM1880E _51 Engine / Hybrid System _013211 2TR-FE FUEL _0068478 FUEL FILTER A

2TR-FE FUEL  FUEL FILTER  REPLACEMENT  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 5.DISCONNECT NO. 1 FUEL HOSE

a.
A252060

Detach the No. 1 fuel hose from the fuel filter.


b.

Disconnect the No. 1 fuel hose (See page Engine / Hybrid System>2TR-FE FUEL>FUEL SYSTEM>PRECAUTION).


Hide 6.DISCONNECT FUEL MAIN TUBE

a.
A252061

Disconnect the fuel main tube (See page Engine / Hybrid System>2TR-FE FUEL>FUEL SYSTEM>PRECAUTION).


Hide 7.REMOVE FUEL FILTER

a.
A252062

Remove the 3 nuts and fuel filter.


Hide 8.INSTALL FUEL FILTER

a.

Install the fuel filter with the 3 nuts.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)


Hide 9.CONNECT FUEL MAIN TUBE

a.

Connect the fuel main tube (See page Engine / Hybrid System>2TR-FE FUEL>FUEL SYSTEM>PRECAUTION).


Hide 10.CONNECT NO. 1 FUEL HOSE

a.

Connect the No. 1 fuel hose (See page Engine / Hybrid System>2TR-FE FUEL>FUEL SYSTEM>PRECAUTION).


b.

Attach the No. 1 fuel hose to the fuel filter.


Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).