1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.REMOVE FUEL TANK CAP ASSEMBLY
5.REMOVE NO. 3 FUEL TUBE CLAMP
Remove the 2 tube clamps from the fuel tube.
6.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY AND FUEL TANK RETURN TUBE
| *1 | Fuel Tank Return Tube |
| *2 | Fuel Tank Main Tube |
| *3 | Vent Line Hose |
Disconnect the fuel tank main tube (See page Engine / Hybrid System>2TR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Disconnect the fuel tank return tube (See page Engine / Hybrid System>2TR-FE FUEL>FUEL SYSTEM>PRECAUTION).
Disconnect the vent line hose from the fuel pipe.
7.DISCONNECT FUEL TANK BREATHER HOSE
Disconnect the fuel tank breather hose from the fuel tank inlet pipe.
Detach the fuel tank breather hose from the 2 clamps.
8.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Disconnect the fuel tank to filler pipe hose from the fuel tank inlet pipe.
9.REMOVE FUEL TANK INLET PIPE SUB-ASSEMBLY
Remove the bolt, nut and fuel tank inlet pipe.
10.REMOVE FUEL TANK ASSEMBLY
Place an engine lifter under the fuel tank.
Remove the 3 bolts, 3 clips, 3 pins and 3 fuel tank bands.
Slightly lower the engine lifter.
Be careful not to cut the wiring.
| *1 | Fuel Tank Cushion |
| *2 | Wire Harness |
| *3 | Fuel Tank |
Fold back approximately half of each cushion so that the wire harness can be removed in the step below.
| *1 | Claw |
Detach the wire harness from the 4 clamps shown in the illustration.
Detach the claws of the clamps labeled A in the illustration to detach the wire harness.
Disconnect the fuel pump and sender gauge connector.
11.REMOVE NO. 1 FUEL TANK HEAT INSULATOR
| *1 | Needle-nose Pliers |
|
Clip |
|
Nut |
Using needle-nose pliers, remove the 5 clips and 2 nuts as shown in the illustration, then remove the No. 1 fuel tank heat insulator.
12.REMOVE FUEL TANK CUSHION
Remove the 2 fuel tank cushions from the fuel tank.
13.REMOVE VENT LINE TUBE
Disconnect the vent line hose and remove the vent line tube.
14.REMOVE FUEL PUMP GAUGE RETAINER
15.REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
16.REMOVE FUEL TANK BREATHER HOSE
Remove the fuel tank breather hose from the fuel tank.
17.REMOVE FUEL TANK TO FILLER PIPE HOSE
Remove the fuel tank to filler pipe hose from the fuel tank.