Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM1880E _53 Suspension _013224 REAR SUSPENSION _0068554 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

Remove the fuel tank before removing the rear upper arm LH, and remove the center exhaust pipe before removing the rear upper arm RH.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 2.REMOVE CENTER EXHAUST PIPE ASSEMBLY

Hide 3.REMOVE FUEL TANK SUB-ASSEMBLY

Hide 4.REMOVE UPPER CONTROL ARM ASSEMBLY

C118723

a.

Remove the 2 bolts, 2 nuts and control arm from the axle housing.

HINT:

While fixing the nuts in place, loosen and remove the bolts.