Home › Suspension › REAR SUSPENSION › REAR LATERAL CONTROL ROD
RM1880E _53 Suspension _013224 REAR SUSPENSION _0068556 REAR LATERAL CONTROL ROD A

REAR SUSPENSION  REAR LATERAL CONTROL ROD  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.TEMPORARILY INSTALL REAR LATERAL CONTROL ROD ASSEMBLY

a.

Install 2 new bushes to the control rod.


b.

Install the control rod and 2 retainers to the axle housing.


c.

Temporarily install the lateral control rod with the bolt and 2 nuts.


Hide 2.INSTALL LOAD SENSING VALVE ASSEMBLY

Hide 4.TIGHTEN REAR LATERAL CONTROL ROD ASSEMBLY

C118725
2.49,3.948 2.781,4.229 0.292,0.281 10 false B 1.313,3.948 1.542,4.177 0.229,0.229 10 false C 1.646,1.615 1.802,1.813 0.156,0.198 10 false A

a.

Tighten the 2 nuts.

Torque:
for nut A : 100 N*m (1020 kgf*cm, 74 ft.*lbf)
for nut B : 96 N*m (979 kgf*cm, 71 ft.*lbf)

HINT:

While fixing the bolt labeled C in place, tighten the nut.