Home › Brake › BRAKE SYSTEM (OTHER) › LOAD SENSING PROPORTIONING VALVE
RM1880E _54 Brake _013227 BRAKE SYSTEM (OTHER) _0068568 LOAD SENSING PROPORTIONING VALVE A

BRAKE SYSTEM (OTHER)  LOAD SENSING PROPORTIONING VALVE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL LOAD SENSING PROPORTIONING VALVE ASSEMBLY

a.

Install the load sensing proportioning valve with the 2 bolts.

Torque:
29 N*m (300 kgf*cm, 22 ft.*lbf)


b.

Install the lock nut.

Torque:
13 N*m (130 kgf*cm, 9 ft.*lbf)


c.

Using a union nut wrench, connect the 3 brake lines to the load sensing proportioning valve assembly.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 3.BLEED AIR FROM CLUTCH LINE (for Manual Transmission)