Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM1880E _52 Drivetrain _013221 AXLE AND DIFFERENTIAL _0068537 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 4.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

Hide 6.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
F050084

Using a dial indicator, check for looseness near the center of the front axle hub.

Maximum:

0.05 mm (0.00197 in.)


NOTICE:

Make sure that the dial indicator is set perpendicular to the measurement surface.


If the looseness is more than the maximum, replace the front axle hub sub-assembly.


Hide 7.INSPECT FRONT AXLE HUB RUNOUT

a.
F050083

Using a dial indicator, check for runout on the surface of the front axle hub inside the front axle hub bolt.

Maximum:

0.05 mm (0.00197 in.)


NOTICE:

Make sure that the dial indicator is set perpendicular to the measurement surface.


If the runout is more than the maximum, replace the front axle hub sub-assembly.


Hide 9.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH

Hide 11.BLEED BRAKE LINE