Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM
RM1880E _54 Brake _013226 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0068558 ANTI-LOCK BRAKE SYSTEM S

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  DIAGNOSTIC TROUBLE CODE CHART  


DTC Chart of ABS
DTC No. Detection Item DTC Detection Condition Note Link
C0200/31 Front Speed Sensor RH Circuit One of the following conditions is met:
1.

At a vehicle speed of 10 km/h (6 mph) or more, an open or short in the sensor signal circuit continues for 15 seconds or more.

2.

Momentary interruption of the sensor signal from the abnormal wheel occurs 7 times or more.

3.

An open in the speed sensor signal circuit continues for 0.5 seconds or more.


- Click here
C0205/32 Front Speed Sensor LH Circuit One of the following conditions is met:
1.

At a vehicle speed of 10 km/h (6 mph) or more, an open or short in the sensor signal circuit continues for 15 seconds or more.

2.

Momentary interruption of the sensor signal from the abnormal wheel occurs 7 times or more.

3.

An open in the speed sensor signal circuit continues for 0.5 seconds or more.


- Click here
C0210/33 Rear Speed Sensor RH Circuit One of the following conditions is met:
1.

At a vehicle speed of 10 km/h (6 mph) or more, an open or short in the sensor signal circuit continues for 15 seconds or more.

2.

Momentary interruption of the sensor signal from the abnormal wheel occurs 7 times or more.

3.

An open in the speed sensor signal circuit continues for 0.5 seconds or more.


- Click here
C0215/34 Rear Speed Sensor LH Circuit One of the following conditions is met:
1.

At a vehicle speed of 10 km/h (6 mph) or more, an open or short in the sensor signal circuit continues for 15 seconds or more.

2.

Momentary interruption of the sensor signal from the abnormal wheel occurs 7 times or more.

3.

An open in the speed sensor signal circuit continues for 0.5 seconds or more.


- Click here
C0226/21 SFR Solenoid Circuit Open or short in the solenoid circuit continues for 0.05 seconds or more. - Click here
C0236/22 SFL Solenoid Circuit Open or short in the solenoid circuit continues for 0.05 seconds or more. - Click here
C0246/23 SRR Solenoid Circuit Open or short in the solenoid circuit continues for 0.05 seconds or more. - Click here
C0273/13 Open in ABS Motor Relay Circuit Either condition is met:
1.

Both conditions are met for 0.2 seconds or more.

·

The IG1 terminal voltage is between 10 and 16 V.

·

Relay contact is open when the relay is on.


2.

Both conditions are met for 0.2 seconds.

·

The IG1 terminal voltage is below 10 V.

·

Relay contact remains open when the relay is on.



- Click here
C0274/14 Short to B+ in ABS Motor Relay Circuit When the motor relay is off, the motor relay remains closed for 4 seconds or more. - Click here
C0278/11 Open in ABS Solenoid Relay Circuit Either condition is met:
1.

Both conditions continue for 0.2 seconds or more.

·

The IG1 terminal voltage is between 10 and 16 V.

·

Relay contact is open when the relay is on.


2.

Both conditions are met for 0.2 seconds or more.

·

The IG1 terminal voltage is below 10 V.

·

Relay contact remains open.



- Click here
C0279/12 Short to B+ in ABS Solenoid Relay Circuit Immediately after the ignition switch is turned to ON, the solenoid relay contact is closed for 0.2 seconds when the relay is turned off. - Click here
C1235/35 Foreign Object is Attached on Tip of Front Speed Sensor RH At a vehicle speed of 20 km/h (12 mph) or more, condition that noise is included in speed sensor signal continues for 5 seconds or more. - Click here
C1236/36 Foreign Object is Attached on Tip of Front Speed Sensor LH At a vehicle speed of 20 km/h (12 mph) or more, condition that noise is included in speed sensor signal continues for 5 seconds or more. - Click here
C1238/38 Foreign Object is Attached on Tip of Rear Speed Sensor RH At a vehicle speed of 20 km/h (12 mph) or more, condition that noise is included in speed sensor signal continues for 5 seconds or more. - Click here
C1239/39 Foreign Object is Attached on Tip of Rear Speed Sensor LH At a vehicle speed of 20 km/h (12 mph) or more, condition that noise is included in speed sensor signal continues for 5 seconds or more. - Click here
C1241/41 Low Battery Positive Voltage or Abnormally High Battery Positive Voltage Either condition is met:
1.

Both conditions continue for at least 10 seconds.

·

Vehicle speed is more than 3 km/h (2 mph).

·

The IG1 terminal voltage is below 9.5 V.


2.

All conditions continue for at least 0.2 seconds

·

Solenoid relay remains on.

·

Relay contact is open.

·

The IG1 terminal voltage is below 9.5 V.



- Click here
C1249/49 Open in Stop Light Switch Circuit When the IG1 terminal voltage is 9.5 V or higher, either condition continues for 0.3 seconds or more.
·

Open circuits in the stop light LH and RH circuits.

·

An open circuit in the ground line of the stop light LH and RH circuits.


- Click here
C1251/51 Open in Pump Motor Circuit Either condition is met:
1.

ABS pump motor does not operate properly.

2.

Open in ABS pump motor circuit continues for at least 2 seconds.


- Click here
C1271/71 Low Output Signal of Front Speed Sensor RH (Test Mode DTC) Detected only during Test Mode. The codes in this table are output only in Test Mode. Click here
C1272/72 Low Output Signal of Front Speed Sensor LH (Test Mode DTC) Detected only during Test Mode. The codes in this table are output only in Test Mode. Click here
C1273/73 Low Output Signal of Rear Speed Sensor RH (Test Mode DTC) Detected only during Test Mode. The code in this table is output only in Test Mode. Click here
C1274/74 Low Output Signal of Rear Speed Sensor LH (Test Mode DTC) Detected only during Test Mode. The code in this table is output only in Test Mode. Click here
C1275/75 Abnormal Change in Output Signal of Front Speed Sensor RH (Test Mode DTC) Detected only during Test Mode. The codes in this table are output only in Test Mode. Click here
C1276/76 Abnormal Change in Output Signal of Front Speed Sensor LH (Test Mode DTC) Detected only during Test Mode. The codes in this table are output only in Test Mode. Click here
C1277/77 Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC) Detected only during Test Mode. The code in this table is output only in Test Mode. Click here
C1278/78 Abnormal Change in Output Signal of Rear Speed Sensor LH (Test Mode DTC) Detected only during Test Mode. The code in this table is output only in Test Mode. Click here
C1337/37 Diameter of the Tire is not Uniform Both conditions continue for at least 60 seconds:
·

Vehicle speed is more than 20 km/h (12 mph)

·

Tire of different size is equipped


- Click here