Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL
RM1880E _54 Brake _013227 BRAKE SYSTEM (OTHER) _0068565 BRAKE PEDAL A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.DISCONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Disconnect the stop light switch connector.


b.
C226773
1.031,2.417 1.031,2.208 1.031,2.208 0.771,2.208 false 1.948,1.208 1.302,0.802 1.302,0.802 1.177,0.802 false 2.177,1.99 2.177,2.781 2.177,2.781 2.281,2.781 true 0.99,0.719 1.344,1.063 0.354,0.344 10 false *1 0.594,2.125 0.917,2.375 0.323,0.25 10 false *3 2.313,2.708 2.76,3.094 0.448,0.385 10 false *2
*1 Brake Pedal Return Spring
*2 Clevis Pin
*3 Clip


Remove the return spring.


c.

Remove the clip and clevis pin.


d.

Disconnect the push rod clevis from the brake pedal.


Hide 5.REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY

a.
C228311
1.404,0.363 2.748,0.526 1.344,0.163 10 *1 2.571,2.886 2.741,3.028 0.17,0.142 10 *2 1.26,1.411 1.26,0.445 1.26,0.445 1.391,0.445 false 2.947,1.635 2.947,2.963 2.947,2.963 2.766,2.963 false
*1 Brake Pedal Support
*2 Instrument Panel Reinforcement


Remove the bolt from the support.


b.
C111300

Remove the 4 nuts and support.