Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER
RM1880E _54 Brake _013227 BRAKE SYSTEM (OTHER) _0068566 BRAKE MASTER CYLINDER A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER  INSTALLATION  


PROCEDURE

Hide 1.CHECK AND ADJUST BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

Hide 2.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

Install a new O-ring to the master cylinder.


b.

Install the master cylinder and bracket (with 3-way) to the booster with the 2 nuts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


c.

Using a union nut wrench, connect the 5 brake lines to the master cylinder and 3-way.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



d.

Connect the brake fluid level warning switch connector to the master cylinder.


e.

for Manual transmission:

Connect the clutch reservoir tube to the master cylinder.


Hide 4.BLEED AIR FROM CLUTCH LINE (for Manual Transmission)