Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE
RM1880E _54 Brake _013228 BRAKE (FRONT) _0068570 FRONT BRAKE FLEXIBLE HOSE A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT FLEXIBLE HOSE

a.

Install a new gasket and connect the front flexible hose to the disc brake cylinder assembly with a new union bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)

NOTICE:

Install the flexible hose lock securely in the lock hole in the cylinder.



b.

Install a new clip to the front flexible hose.

NOTICE:

Make sure the clip to the front flexible hose.



c.

Using a union nut wrench, connect the brake line to the front flexible hose while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt and dust to enter the brake line from the connecting point.

·

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).




d.

Install the front flexible hose to the absorber bracket with the bolt.

Torque:
29 N*m (296 kgf*cm, 21 ft.*lbf)


Hide 3.BLEED AIR FROM CLUTCH LINE (for Manual Transmission)