Home › Brake › PARKING BRAKE › PARKING BRAKE LEVER
RM1880E _54 Brake _013230 PARKING BRAKE _0068574 PARKING BRAKE LEVER A

PARKING BRAKE  PARKING BRAKE LEVER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.REMOVE PARKING BRAKE LEVER COVER

Hide 5.REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY

a.
C237675
1.563,0.969 0.479,0.969 true 1.521,1.125 0.865,1.646 0.865,1.646 0.5,1.646 true 0.313,0.885 0.458,1.042 0.146,0.156 10 false *1 0.333,1.552 0.479,1.708 0.146,0.156 10 false *2
*1 Lock Nut
*2 No. 1 Parking Brake Cable Adjusting Nut


Remove the lock nut and No. 1 parking brake cable adjusting nut.


b.
C237673

Remove the 2 bolts and lever (with the No. 1 parking brake cable).


c.
C237678
2.385,2.75 2.385,2.938 2.385,2.938 2.115,2.938 false 1.958,2.844 2.125,3 0.167,0.156 10 false *1
*1 Claw


Bend the claw so that the No. 1 parking brake cable can be removed.


d.
C238705

Remove the 2 bolts and 2 nuts.


e.

Disconnect the cable from the lever.


f.
C237685

Disconnect the parking brake switch connector.


g.

Remove the screw and switch from the lever.