Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE STEERING PAD
4.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
5.REMOVE NO. 2 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
| *1 | Pin |
Remove the screw.
Detach the 2 pins and remove the steering wheel ornament.
6.REMOVE NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
| *1 | Pin |
Remove the screw.
Detach the 2 pins and remove the steering wheel ornament.
7.REMOVE STEERING WHEEL ASSEMBLY
Remove the steering wheel assembly set nut.
| *1 | Matchmark |
| *a | Turn |
| *b | Hold |
Put matchmarks on the steering wheel assembly and steering main shaft.
Using SST, remove the steering wheel assembly.
Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.