Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068584 RADIO RECEIVER A

AUDIO / VIDEO  RADIO RECEIVER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 2 RADIO BRACKET (for Radio and Display Type)

a.
E226346

Install the No. 2 radio bracket to the radio and display receiver with the 4 screws.


Hide 2.INSTALL NO. 2 RADIO BRACKET (for Radio Receiver Type)

a.
E226345

Install the No. 2 radio bracket to the radio receiver with the 3 screws.


Hide 3.INSTALL NO. 1 RADIO BRACKET (for Radio and Display Type)

a.
E226344

Install the No. 1 radio bracket to the radio and display receiver with the 4 screws.


Hide 4.INSTALL NO. 1 RADIO BRACKET (for Radio Receiver Type)

a.
E226343

Install the No. 1 radio bracket to the radio receiver with the 3 screws.


Hide 5.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)

a.
E226342

Connect all the connectors.


b.

Install the radio and display receiver assembly with bracket with the 4 screws.


Hide 6.INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

a.
E226341

Connect all the connectors.


b.

Install the radio receiver assembly with bracket with the 4 screws.


Hide 7.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 8.INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).