Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068585 FRONT DOOR SPEAKER A

AUDIO / VIDEO  FRONT DOOR SPEAKER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 4.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

a.
E226350

Disconnect the connector.


b.

Remove the nut and front No. 2 speaker assembly.


Hide 5.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

Hide 6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 7.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

a.
E234275
1.667,0.313 1.927,0.615 0.26,0.302 10 false A

Disconnect the connector.


b.

Put a 5 mm (0.197 in.) drill bit into a drill.


c.

Wind tape around the drill bit approximately 4 mm (0.157 in.) from the tip of the drill as shown in the illustration.

NOTICE:

Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going to deep.


Standard
Area Specified Condition
A 4 mm (0.157 in.)


d.

Lightly press the drill against the 3 rivets, drill off the flanges of the 3 rivets and remove the front No. 1 speaker assembly.

CAUTION:

Be careful of the drilled rivet as it may become hot.


NOTICE:
·

Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

·

Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.




e.

Continue drilling and push out the remaining rivet fragments.


f.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.