Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068588 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.REMOVE ANTENNA CORD SUB-ASSEMBLY

a.

Disconnect the connectors.

E226371


b.

Detach the 4 clamps shown in the illustration and remove the antenna cord.


Hide 5.REMOVE ANTENNA CORD SUB-ASSEMBLY (for Glass Antenna Type)

a.

Disconnect the connectors.

E226372


b.

Detach the 5 clamps shown in the illustration.


c.

Remove the clamp bolt and antenna cord.