Home › Audio / Visual / Telematics › AUDIO / VIDEO › AMPLIFIER ANTENNA
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068589 AMPLIFIER ANTENNA A

AUDIO / VIDEO  AMPLIFIER ANTENNA  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE ROOF HEADLINING ASSEMBLY

Hide 4.REMOVE WITH HOLDER ANTENNA ASSEMBLY

a.

Disconnect the connector.

E226376


b.

Detach the 15 clamps.


c.
B176768

Disconnect the 2 connectors.


d.

Remove the bolt and antenna.