Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type)
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068594 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  B1550  DAB Tuner Malfunction  B1552  Extension Module Malfunction  B1564  Digital Radio Disconnected  B156C  Extension Module Disconnected  B157D  DAB Tuner Antenna Disconnected  B157E  Bluetooth Antenna Disconnected  B158A  Extension Module Noise Adjustment Malfunction  


DESCRIPTION

These DTCs are stored when a malfunction occurs in optional equipment.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1550 DAB Tuner Malfunction Digital radio tuner has a malfunction. Radio and display receiver assembly
B1552 Extension Module Malfunction Extension module has a malfunction. Radio and display receiver assembly
B1564 Digital Radio Disconnected Digital radio tuner is disconnected.
·

Radio and display receiver assembly

·

Harness or connector


B156C Extension Module Disconnected Extension module is disconnected.
·

Radio and display receiver assembly

·

Harness or connector


B157D DAB Tuner Antenna Disconnected DAB Tuner Antenna Disconnected.
·

Radio and display receiver assembly

·

Harness or connector


B157E Bluetooth Antenna Disconnected Bluetooth Antenna Disconnected.
·

Radio and display receiver assembly

·

Harness or connector


B158A Extension Module Noise Adjustment Malfunction Extension module noise adjustment malfunction is present.
·

Radio and display receiver assembly

·

Harness or connector



PROCEDURE

1.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
a.

Disconnect the connector for optional equipment from the radio and display receiver assembly.


b.

Check that there are no damage in terminals or parts of the radio and display receiver assembly connector.

OK:

There are no damage in terminals or parts.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

2.CHECK HARNESS AND CONNECTOR
a.

Check that there are no damage in terminals or parts in the optional equipment connector.

OK:

There are no damage in terminals or parts.



Result:
Proceed to
OK
NG



OK

3.CHECK FOR DTC

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK FOR DTC

b.

Check for DTCs and check if the same trouble occurs again.

OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

4.REPAIR OR REPLACE OPTIONAL EQUIPMENT
4.REPAIR OR REPLACE OPTIONAL EQUIPMENT
a.

Refer to optional equipment's manual for repair information.


Result:
Proceed to
NEXT



NEXT

5.CHECK FOR DTC
5.CHECK FOR DTC

b.

Check for DTCs and check if the same trouble occurs again.

OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY