Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING BUZZER
RM1880E _56 Audio / Visual / Telematics _013235 PARK ASSIST / MONITORING _0068595 CLEARANCE WARNING BUZZER A

PARK ASSIST / MONITORING  CLEARANCE WARNING BUZZER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

a.

Remove the upper instrument panel (See page Vehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL).


Hide 4.REMOVE NO. 1 CLEARANCE WARNING BUZZER

a.
E227766

Disconnect the connector.


b.

Detach the clamp and remove the No. 1 clearance warning buzzer.