Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK
RM1880E _58 Vehicle Interior _013237 DOOR LOCK _0068611 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 1.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

Hide 2.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

Hide 3.INSTALL FRONT DOOR LOCK ASSEMBLY LH

a.

Install a new door lock wiring harness seal to the front door lock assembly.

NOTICE:
·

When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the surface of the connector which contacts the door lock wiring harness seal.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may allow water into the connection. This may result in a malfunction of the front door lock assembly.




b.

Apply MP grease to the sliding parts of the front door lock assembly.


c.
B292263

Insert the front door lock open rod into the front door lock assembly.


d.

Check that the front door lock open rod is securely connected to the front door lock assembly.


e.

Using a T30 "TORX" wrench, install the front door lock assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


f.
B292261
1.938,1.146 1.938,0.854 false 2.344,0.604 2.49,1.083 2.49,1.083 2.823,1.083 true 1.469,0.177 1.625,0.177 1.625,0.177 1.917,0.708 true 1.281,0.104 1.552,0.344 0.271,0.24 10 *1 1.875,1.198 2.115,1.448 0.24,0.25 10 *2 2.854,1 3.104,1.26 0.25,0.26 10 *3
*1 Front Door Inside Locking Cable Assembly LH
*2 Front Door Lock Remote Control Cable Assembly LH
*3 Door Lock Link Clamp


Connect the door lock connector.


g.

Attach the claw and connect the front door lock remote control cable assembly to the door lock link clamp.


h.

Attach the claw and connect the front door inside locking cable assembly to the door lock link clamp.


Hide 4.INSTALL FRONT DOOR OUTSIDE HANDLE COVER

Hide 5.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

Hide 6.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 7.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 8.INSTALL FRONT DOOR NO. 1 TRIM BRACKET

Hide 9.INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH

Hide 10.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 11.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

Hide 12.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).