Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK
RM1880E _58 Vehicle Interior _013237 DOOR LOCK _0068611 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See pageGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION ).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 4.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

Hide 5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 6.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH

Hide 7.REMOVE FRONT DOOR NO. 1 TRIM BRACKET

Hide 8.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 9.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 10.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

Hide 11.REMOVE FRONT DOOR OUTSIDE HANDLE COVER

Hide 12.REMOVE FRONT DOOR LOCK ASSEMBLY LH

a.
B292261
1.938,1.146 1.938,0.854 false 2.344,0.604 2.49,1.083 2.49,1.083 2.823,1.083 true 1.469,0.177 1.625,0.177 1.625,0.177 1.917,0.708 true 1.281,0.104 1.552,0.344 0.271,0.24 10 *1 1.875,1.198 2.115,1.448 0.24,0.25 10 *2 2.854,1 3.104,1.26 0.25,0.26 10 *3
*1 Front Door Inside Locking Cable Assembly LH
*2 Front Door Lock Remote Control Cable Assembly LH
*3 Door Lock Link Clamp


Detach the claw and disconnect the front door lock remote control cable assembly from the door lock link clamp.


b.

Detach the claw and disconnect the front door inside locking cable assembly from the door lock link clamp.


c.

Disconnect the connector.


d.
B292262

Using a T30 "TORX" wrench, remove the 3 screws.


e.

Slide the front door lock assembly downward, disconnect the front door lock assembly from the front door lock open rod, and remove the front door lock assembly and cables as a unit.


f.

Remove the door lock wiring harness seal from the front door lock assembly.


Hide 13.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

Hide 14.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH