Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM1880E _58 Vehicle Interior _013237 DOOR LOCK _0068612 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 4.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 5.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

Hide 6.REMOVE REAR DOOR NO. 2 TRIM BRACKET

Hide 7.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 8.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 9.REMOVE REAR DOOR GLASS RUN LH

Hide 10.REMOVE REAR DOOR QUARTER WINDOW GLASS LH

Hide 11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 12.REMOVE REAR DOOR LOCK ASSEMBLY LH

a.
B292269
2.167,0.167 2.417,0.167 2.417,0.167 2.646,0.49 true 2.75,0.917 2.75,0.688 true 2.24,0.865 2.24,1.198 2.24,1.198 1.823,1.448 true 1.906,0.083 2.167,0.333 0.26,0.25 10 *1 2.667,0.927 2.917,1.177 0.25,0.25 10 *2 1.635,1.385 1.854,1.583 0.219,0.198 10 *3
*1 Rear Door Inside Locking Cable Assembly LH
*2 Rear Door Lock Remote Control Cable Assembly LH
*3 Door Lock Link Clamp


Detach the claw and disconnect the rear door lock remote control cable assembly from the door lock link clamp.


b.

Detach the claw and disconnect the rear door inside locking cable assembly from the door lock link clamp.


c.

Disconnect the connector.


d.
B292270

Using a T30 "TORX" wrench, remove the 3 screws.


e.

Slide the rear door lock assembly downward, disconnect the rear door lock assembly from the door outside handle release plate, and remove the rear door lock assembly and cables as a unit.


f.

Remove the door lock wiring harness seal from the rear door lock assembly.


Hide 13.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

Hide 14.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH