Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL TRANSPONDER KEY AMPLIFIER
Connect the transponder key amplifier connector.
Align the claw of the transponder key amplifier with the upper bracket.
Push in the transponder key amplifier and install it to the upper bracket.
Do not push in the transponder key amplifier with excessive force as it may be damaged.
2.INSTALL STEERING COLUMN UPPER COVER
3.INSTALL STEERING COLUMN LOWER COVER
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).