Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE STEERING WHEEL ASSEMBLY
4.REMOVE STEERING COLUMN LOWER COVER
Remove the 3 bolts and lower cover.
5.REMOVE STEERING COLUMN UPPER COVER
Detach the claw and remove the upper cover.
6.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Disconnect the connectors from the combination switch assembly with spiral cable sub-assembly.
| *1 | Clamp |
| *2 | Claw |
Use pliers to hold the clamp and raise the claw with a screwdriver. Remove the combination switch assembly with spiral cable sub-assembly from the steering column assembly.
7.REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL
8.DISCONNECT STEERING SLIDING YOKE
9.REMOVE STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Remove the 3 bolts and cover.
10.REMOVE STEERING COLUMN ASSEMBLY
Disconnect the connectors and detach the wire harness clamps from the steering column.
Remove the 3 bolts and pull out the steering column together with the steering sliding with coupling yoke.