Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT WARNING ECU
RM1880E _58 Vehicle Interior _013238 THEFT DETERRENT / KEYLESS ENTRY _0068621 THEFT WARNING ECU A

THEFT DETERRENT / KEYLESS ENTRY  THEFT WARNING ECU  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 1.INSTALL THEFT WARNING ECU ASSEMBLY

a.

Install the theft warning ECU assembly with the bolt.


b.

Connect the connector.


Hide 2.INSTALL COMBINATION METER ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).