Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT AIRBAG SENSOR
RM1880E _58 Vehicle Interior _013242 SUPPLEMENTAL RESTRAINT SYSTEMS _0068640 FRONT AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT AIRBAG SENSOR LH

a.

Install the front airbag sensor LH with the nut.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the front airbag sensor LH has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the front airbag sensor LH, make sure that the SRS wiring does not interfere with other parts and is not pinched between other parts.




b.

Check that the front airbag sensor LH is not loose.


c.

Connect the connector.


Hide 2.INSTALL BATTERY

a.

Install the battery.


b.

Connect the cable to the positive (+) battery terminal.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 3.INSTALL BATTERY CLAMP SUB-ASSEMBLY

a.

Install the battery clamp with the bolt and nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).