Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY RH
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH
3.REMOVE FRONT SEAT CUSHION COVER RH
Remove the front seat cushion cover RH.
4.REMOVE FRONT SEAT INNER CUSHION SHIELD RH
Remove the 2 screws.
Detach the 2 hooks in the order shown in the illustration and remove the front seat inner cushion shield RH.
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
| *1 | Protective Tape |
Raise the reclining adjuster release handle to reveal the claw. Using a screwdriver, detach the claw and remove the reclining adjuster release handle RH.
Tape the screwdriver tip before use.
6.REMOVE FRONT SEAT CUSHION SHIELD RH
| *1 | Hook |
| *2 | Guide |
Remove the 2 screws.
Detach the 2 hooks in the order shown in the illustration, and then detach the guide and remove the front seat cushion shield RH.
7.REMOVE SEATBACK SPRING RH
Remove the seatback spring RH.
8.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH
Remove the 4 bolts and separate type front seatback assembly RH.
9.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER RH
Detach the wire harness clamp.
Remove the hog rings.
Bend the 2 front seat cushion frame claws upward.
Detach the hooks and remove the separate type front seat cushion cover with pad from the front seat cushion frame sub-assembly RH.
Remove the hog rings and separate type front seat cushion cover.
| *A | for Vinyl Seat, for Cloth Seat | *B | for Leather Seat |