A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
1.INSTALL REAR SEAT LAP TYPE BELT ASSEMBLY LH
| *1 | Protruding Part |
Install the rear seat lap type belt assembly LH with the bolt.
Do not allow the anchor part of the seat inner belt to overlap the protruding parts of the seat frame.
2.INSTALL REAR CENTER SEAT LAP TYPE BELT ASSEMBLY
| *1 | Protruding Part |
Install the rear center seat lap type belt assembly with the bolt.
Do not allow the anchor part of the seat inner belt to overlap the protruding parts of the seat frame.
3.INSTALL REAR NO. 1 SEAT CUSHION PAD RH
4.INSTALL REAR NO. 1 SEAT CUSHION COVER RH
5.INSTALL REAR SEAT TRACK ASSEMBLY RH
6.INSTALL SEAT TRACK ADJUSTING HANDLE
7.INSTALL REAR SEAT LOCK ASSEMBLY RH
8.INSTALL REAR SEAT CUSHION SUPPORT SPRING
9.INSTALL REAR SEAT LOCK ASSEMBLY LH
10.INSTALL REAR SEAT LOCK CONTROL CABLE RH
11.INSTALL REAR SEAT HINGE ASSEMBLY LH
12.INSTALL REAR SEAT HINGE ASSEMBLY RH
13.INSTALL NO. 1 SEAT LEG LINK
14.INSTALL LOWER SEAT TRACK RAIL PROTECTOR LH
15.INSTALL LOWER SEAT TRACK RAIL PROTECTOR RH
16.INSTALL REAR SEAT INNER LOCK COVER RH
17.INSTALL REAR SEAT OUTER LOCK COVER RH
18.INSTALL REAR PROTECTOR PIPE
19.INSTALL RECLINING RELEASE HANDLE SUB-ASSEMBLY
20.INSTALL REAR SEAT LOCK COVER RH
21.INSTALL REAR SEATBACK LOCK RELEASE BUTTON
22.INSTALL REAR NO. 1 SEATBACK ASSEMBLY RH
23.INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY RH
| *1 | Protruding Part |
Install the rear No. 1 seat inner belt assembly RH with the bolt.
Do not allow the anchor part of the seat inner belt to overlap the protruding parts of the seat frame.
24.INSTALL REAR NO. 1 SEAT RECLINING COVER RH
25.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH
26.INSTALL REAR NO. 1 SEAT RECLINING COVER LH
27.INSTALL REAR NO. 1 SEAT ASSEMBLY RH