Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT OUTER BELT ASSEMBLY
RM1880E _58 Vehicle Interior _013244 SEAT BELT _0068658 REAR NO. 1 SEAT OUTER BELT ASSEMBLY A

SEAT BELT  REAR NO. 1 SEAT OUTER BELT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 1.INSTALL REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

a.
B342843

Align the seat outer belt positioning holes with the claws and install the retractor of the rear No. 1 seat outer belt assembly LH with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


b.
B282392

Connect the rear No. 1 seat outer belt shoulder anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


c.
B278424

Attach the 2 claws to close the cover.


Hide 2.INSTALL QUARTER INSIDE TRIM BOARD LH

a.

Attach the 4 claws, 8 clips and 2 guides to install the quarter inside trim board LH.


b.

Install the clip.


c.

Connect the rear No. 1 seat outer belt floor anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


d.

w/ Rear No. 2 Seat:

Connect the rear No. 2 seat outer belt floor anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 4.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 7.INSTALL REAR NO. 2 SEAT ASSEMBLY LH