Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT OUTER BELT ASSEMBLY
RM1880E _58 Vehicle Interior _013244 SEAT BELT _0068658 REAR NO. 1 SEAT OUTER BELT ASSEMBLY A

SEAT BELT  REAR NO. 1 SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR NO. 2 SEAT ASSEMBLY LH

Hide 4.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

a.

Partially remove the rear door opening trim weatherstrip LH so that the quarter inside trim board LH can be removed (see page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 6.REMOVE QUARTER INSIDE TRIM BOARD LH

B289605

a.

Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.


b.
B289606

Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor.


c.

Remove the clip.


d.
B289607

Detach the 4 claws, 8 clips and 2 guides and remove the quarter inside trim board.


Hide 7.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

a.
B155349

Remove the shoulder anchor of the rear No. 1 seat outer belt assembly LH.

i.

Using a screwdriver, detach the 2 claws and open the shoulder anchor cover as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



ii.

Remove the bolt and disconnect the rear No. 1 seat outer belt shoulder anchor.



b.
B342842

Remove the bolt and rear No. 1 seat outer belt assembly LH.