Home › Vehicle Interior › SEAT BELT › REAR NO. 2 SEAT OUTER BELT ASSEMBLY
RM1880E _58 Vehicle Interior _013244 SEAT BELT _0068659 REAR NO. 2 SEAT OUTER BELT ASSEMBLY A

SEAT BELT  REAR NO. 2 SEAT OUTER BELT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 1.INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH

B289611

a.

Align the seat outer belt positioning holes with the claws and install the retractor of the seat outer belt with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


b.
B282392

Connect the shoulder anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


c.

Close the cover cap.


Hide 2.INSTALL QUARTER INSIDE TRIM BOARD LH

a.

Attach the 4 claws, 8 clips and 2 guides to install the quarter inside trim board LH.


b.

Install the clip.


c.

Connect the rear No. 1 seat outer belt floor anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


d.

Connect the rear No. 2 seat outer belt floor anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 4.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 7.INSTALL REAR NO. 2 SEAT ASSEMBLY LH