Home › Vehicle Interior › SEAT BELT › REAR NO. 2 SEAT OUTER BELT ASSEMBLY
RM1880E _58 Vehicle Interior _013244 SEAT BELT _0068659 REAR NO. 2 SEAT OUTER BELT ASSEMBLY A

SEAT BELT  REAR NO. 2 SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR NO. 2 SEAT ASSEMBLY LH

Hide 4.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

a.

Partially remove the rear door opening trim LH so that the quarter inside trim board LH can be removed (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 7.REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH

B282388

a.

Using a screwdriver, detach the 2 claws and open the seat belt anchor cover as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



b.

Remove the bolt and disconnect the rear No. 2 seat outer belt shoulder anchor.


c.
B289610

Remove the bolt and rear No. 2 seat outer belt assembly LH.