The air conditioning amplifier assembly monitors signals from the speedometer sensor via the combination meter assembly. The air conditioning amplifier assembly uses these signals to adjust the thermistor signal.
Check that the speedometer in the combination meter assembly operates normally before inspecting the vehicle speed signal circuit (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>Speed Signal Circuit).
Disconnect the G19 combination meter assembly connector.
Disconnect the G94 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G19-6 (+S) - G94-9 (SPD) | Always | Below 1 Ω |
| G94-9 (SPD) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the air conditioning amplifier assembly with its connectors still connected.
| *a | Component with harness connected
(Air Conditioning Amplifier Assembly) |
Using an oscilloscope, check the waveform of the air conditioning amplifier assembly.
| Item | Content |
|---|---|
| Tester Connection | G94-9 (SPD) - Body ground |
| Tool Setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Driving at approximately 20 km/h (12 mph) |
Waveform is as shown in the illustration.
As the vehicle speed increases, the wavelength becomes shorter.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the combination meter with its connector still connected.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL
| *a | Component with harness connected
(Combination Meter Assembly) |
Using an oscilloscope, check the waveform of the combination meter assembly.
| Item | Content |
|---|---|
| Tester Connection | G19-6 (+S) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Vehicle is driven at approximately 20 km/h (12 mph) |
Waveform is as shown in the illustration.
As the vehicle speed increases, the wavelength becomes shorter.
| Proceed to |
|---|
| OK |
| NG |
OK
NG