Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR
RM1880E _59 Vehicle Exterior _013251 WIPER / WASHER _0068727 REAR WIPER MOTOR A

WIPER / WASHER  REAR WIPER MOTOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE BACK DOOR TRIM BOARD ASSEMBLY

Hide 4.REMOVE REAR WIPER ARM AND BLADE ASSEMBLY

a.
E226546

Open the wiper arm head cap.


b.
E226547

Remove the nut and the arm and blade.


Hide 5.REMOVE REAR WIPER MOTOR ASSEMBLY

a.
B117895

Disconnect the connector.


b.

Remove the 3 bolts and wiper motor.


Hide 6.REMOVE REAR WIPER MOTOR GROMMET

a.
E226548

Remove the rear wiper motor grommet.