Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
Attach the claw to install the windshield wiper switch assembly.
Do not push the claw with excessive force as damage may occur.
Connect the connectors.
2.INSTALL STEERING COLUMN UPPER COVER
3.INSTALL STEERING COLUMN LOWER COVER
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).