Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM1880E _59 Vehicle Exterior _013251 WIPER / WASHER _0068730 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE STEERING COLUMN LOWER COVER

Hide 4.REMOVE STEERING COLUMN UPPER COVER

Hide 5.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

a.
E226570

Disconnect the connectors.


b.

Detach the claw and remove the windshield wiper switch assembly.

NOTICE:

Do not push the claw with excessive force as damage may occur.