Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING
RM1880E _59 Vehicle Exterior _013254 EXTERIOR PANELS / TRIM _0068756 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

a.

Attach the 5 claws to install the rear door belt moulding.


Hide 2.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 3.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 4.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 5.INSTALL REAR DOOR GLASS RUN LH

Hide 6.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 7.INSTALL REAR DOOR NO. 2 TRIM BRACKET

Hide 8.INSTALL REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

Hide 9.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 10.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).