Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING
RM1880E _59 Vehicle Exterior _013254 EXTERIOR PANELS / TRIM _0068756 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 4.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 5.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

Hide 6.REMOVE REAR DOOR NO. 2 TRIM BRACKET

Hide 7.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 8.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 9.REMOVE REAR DOOR GLASS RUN LH

Hide 10.REMOVE REAR DOOR QUARTER WINDOW GLASS LH

Hide 11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 12.REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH

a.
B282269
0.875,1.563 1.094,1.563 1.094,1.563 1.24,1.24 false 0.625,1.448 0.896,1.667 0.271,0.219 10 false *1
*1 Protective Tape


Put protective tape around the rear door belt moulding.


b.

Detach the 5 claws and remove the rear door belt moulding.