Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER › from 2013.08
RM1880E _51 Engine / Hybrid System _013216 2TR-FE STARTING _0068502 STARTER A

2TR-FE STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL STARTER ASSEMBLY

a.

for Automatic Transmission:

i.

Install the starter with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)



b.

for Manual Transmission:

i.

Temporarily install the starter with the bolt


ii.

Temporarily install the clutch flexible hose bracket with the bolt.


iii.

Tighten the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)



c.

Install the starter wire to terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Attach the terminal cap.


e.

Connect the starter connector.


Hide 2.INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)

Hide 3.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 4.INSTALL FRONT FENDER SEAL

a.

Install the fender seal with the 5 clips.


Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).