1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE STARTER ASSEMBLY
4.REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)
5.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
6.REMOVE FRONT UPPER FENDER APRON SEAL
Remove the 6 clips and front upper fender apron seal.
7.REMOVE PURGE VSV
8.REMOVE INTAKE MANIFOLD
Detach the 3 wire harness clamps from the 2 wire harness clamp brackets.
Detach the No. 1 fuel hose from the intake manifold.
for RHD:
Remove the bolt and disconnect the engine wire.
| *A | for Automatic transmission |
| *B | for Manual Transmission |
Detach the No. 2 water by-pass hose.
Disconnect the No. 3 PCV hose and vacuum hose from the intake manifold.
for Automatic Transmission:
Remove the bolt and oil filler tube bracket.
Remove the 5 bolts, 2 nuts and intake manifold.
Remove the gasket from the intake manifold.
Remove the 2 bolts and 2 wire harness clamp brackets from the intake manifold.
Remove the purge line hose from the intake manifold.