2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the following procedure to troubleshoot the TOYOTA parking assist-sensor system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.INSPECT BATTERY VOLTAGE
      1. Measure the battery voltage with the engine switch off.

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

      NEXT

      4.CHECK CAN COMMUNICATION SYSTEM*
      1. Use the GTS to check if the CAN communication system is functioning normally.

        Result 
        Result
        Proceed to
        CAN DTC is not output
        A
        CAN DTC is output (for LHD with Entry and Start System)
        B
        CAN DTC is output (for LHD without Entry and Start System)
        C
        CAN DTC is output (for RHD with Entry and Start System)
        D
        CAN DTC is output (for RHD without Entry and Start System)
        E


      B.

      C.

      D.

      E.
      A

      5.CHECK LIN COMMUNICATION SYSTEM*
      1. Use the GTS to check if the LIN communication system is functioning normally.

        Result 
        Result
        Proceed to
        LIN communication system DTC is not output
        A
        LIN communication system DTC is output
        B


      B.
      A

      6.CHECK METER/GAUGE SYSTEM*
      1. Use the GTS to check if the meter/gauge system is functioning normally.

        Result 
        Result
        Proceed to
        Meter/gauge system DTC B2660 is not output
        A
        Meter/gauge system DTC B2660 is output
        B


      B.
      A

      7.PROBLEM SYMPTOM CONFIRMATION
        NEXT

        8.CHECK DTC*
        1. Check for DTCs (Click here).

          Result 
          Result
          Proceed to
          DTC is output
          A
          DTC is not output (Problem symptom does not occur)
          B
          DTC is not output (Problem symptom occurs)
          C


        B.

        C.
        A

        9.DIAGNOSTIC TROUBLE CODE CHART
        1. Refer to Diagnostic Trouble Code Chart (Click here).

        NEXT

        10.SYMPTOM SIMULATION
        1. Refer to Symptom Simulation (Click here).

        NEXT

        11.PROBLEM SYMPTOMS TABLE
        1. Refer to Problem Symptoms Table (Click here).

          Result 
          Result
          Proceed to
          Fault is not listed in problem symptoms table
          A
          Fault is listed in problem symptoms table
          B


        B.
        A

        12.OVERALL ANALYSIS AND TROUBLESHOOTING*
        1. Operation Check (Click here)

        2. Terminals of ECU (Click here)

        3. Data List / Active Test (Click here)

        NEXT

        13.CIRCUIT INSPECTION*
        1. Adjust, repair or replace as necessary.

        NEXT

        14.IDENTIFICATION OF PROBLEM
          NEXT

          15.REPAIR OR REPLACE
            NEXT

            16.CONFIRMATION TEST*
              NEXT

              ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)OPERATION CHECK (Aug 2013 – Jul 2014) →